Whether it's a jammed flywheel from a stray utensil or a motor that's finally worn out after years of use, our Hollis, NH disposal team handles the repair or replacement in a single visit in most cases.
If a disposal is old and the repair cost approaches replacement cost, we'll tell you honestly instead of patching it.
Disposal work involves both plumbing and electrical connections — our Hollis technicians are trained and insured for both.
A non-functioning disposal gets prompt scheduling since it affects daily kitchen use.
Pricing is confirmed upfront whether it's a jam clearing or a full unit swap.
From a simple jammed flywheel to a full unit replacement, we diagnose before recommending the fix.
A disposal that hums but won't spin usually has something lodged in the flywheel, cleared safely with the power disconnected first.
{A motor that's overheating, tripping the reset repeatedly, or making grinding noises gets diagnosed for repair versus replacement.|We test motor function and electrical connections together, since either can cause similar symptoms.}
When a unit is beyond repair, we install a properly sized replacement matched to your sink and usage needs.
Water pooling under the sink often traces to a worn seal or gasket in the disposal, repaired or the unit resealed.
We check the wiring and connection, not just the reset button, to find the actual cause of repeated tripping.
Persistent odors from the disposal are addressed with a proper flush and inspection of the drain trap beyond the unit itself.
Describe the symptoms to dispatch — humming, tripping, leaking, or completely dead — to help route the right service.
A technician arrives within the scheduled window ready to diagnose the unit and connections.
The disposal is diagnosed, and you'll get an honest repair-versus-replace recommendation with a flat price.
We run the disposal through a complete test cycle before calling the job done, then back it with a warranty.
"Disposal was humming but not spinning — cleared a jammed utensil in minutes and it works fine now." — Homeowner, Hollis
"Leak under the sink turned out to be the disposal seal, not the drain pipe I assumed." — Hollis resident
"Appreciated the honest repair-or-replace conversation instead of an automatic upsell." — Hollis customer
We serve Hollis proper and nearby Hollis, NH communities for disposal repair and replacement.
Almost always something jammed in the flywheel — often a stray utensil or bone fragment — clearable in most cases.
Units past 8-10 years with a significant failure often make more sense to replace — we'll give you honest numbers on both.
It depends on the issue — a jam clearing costs far less than a full replacement. We quote upfront before starting.
Often an electrical issue or an overloaded motor from grinding something too tough — we diagnose which it is.
We isolate the leak source first since a seal repair is much less costly than a full swap.
Yes, we install customer-supplied disposals as long as they're properly sized for your sink and usage.
